Stepper Motor 1000mm Cable JST PH6 female to Dupont 4P female (Crossover)

Product Description Want create site? Find Free WordPress Themes and plugins.1000mm JST PH6 (6 pin, 2mm pitch) to Dupont 4 pin 2.54mm pitch connector Compatible with stepper motors with a 6 Pin JST PH2.00 type connector (male on stepper) Connects a 6 Pin socketed Stepper Motor to a controller board following the Ramps 1.4 4 Pin Stepper Header pattern Stepper motor is expected to be wired internally using the ‘Crossover’ pattern (See reference image at the bottom of this listing) If you use this cable and your stepper ‘wriggles’ but does not turn your stepper is most likely wired internally using the ‘Straight’ pattern, to correct you can usually just swap the middle wires (swap the middle 2 pins at the Dupont connector end is probably easiest) Stepper end Pin 1 connects to Driver end Dupont Pin 1 Stepper endPin 2: NC (No connection) Stepper endPin 3: connects to Driver end Dupont Pin 3 Stepper endPin 4: connects to Driver end Dupont Pin 2 Stepper endPin 5: NC (No connection) Stepper endPin 6: connects to Driver end Dupont Pin 4 Note the colour of the cables we get changes from time to time, you may get a cable with Red, Yellow, Gray, Green or you may get Red, Black, Blue, Green or in future who knows what colours.  (Either colour set is functionally identical) 1/8/2021 SKU updated from to CA.6P-4P.ST.FF.1000.XOVR to CA.PH6F-DUP4F.1000.XOVR Did you find apk for android? You can find new Free Android Games and apps.